Comments for CNC ECourse Day 1 Introduction to CNC Video at http://www.cncinformation.com , comment 0 to 6 out of 6 comments http://www.cncinformation.com Sat, 22 Nov 2008 08:08:14 +0100 FeedCreator 1.7.2 http://www.cncinformation.com/cnc-ecourse-videos-learn-cnc-cnc-basics-video/cnc-ecourse-day-1-introduction-to-cnc-video-2#pc_24 GRACIAS LOS VIDEOS - GCHF381 Thu, 26 Jun 2008 09:41:14 +0100 http://www.cncinformation.com/cnc-ecourse-videos-learn-cnc-cnc-basics-video/cnc-ecourse-day-1-introduction-to-cnc-video-2#pc_21 Thanks for the Intro... Can't wait to get started.. Looking forward to the rest of the Course. Thanks Again, Jay - gusjdj Tue, 27 May 2008 10:08:39 +0100 http://www.cncinformation.com/cnc-ecourse-videos-learn-cnc-cnc-basics-video/cnc-ecourse-day-1-introduction-to-cnc-video-2#pc_19 Enjoyed the introduction and am looking forward to the rest of the course. - Dean Thu, 01 May 2008 13:53:12 +0100 http://www.cncinformation.com/cnc-ecourse-videos-learn-cnc-cnc-basics-video/cnc-ecourse-day-1-introduction-to-cnc-video-2#pc_7 Hello Bob, I just checked this out and it looks like the CNC Video is working correctly. Let me know if you have any other problems. Sometimes I am at the mercy of YouTube. If they do maintenance on their site, then CNC Information suffers. Ivan - ivanirons Sat, 15 Mar 2008 16:41:58 +0100 http://www.cncinformation.com/cnc-ecourse-videos-learn-cnc-cnc-basics-video/cnc-ecourse-day-1-introduction-to-cnc-video-2#pc_6 I dont see the video only the transscript of the video is something wrong? Bob rtnmi - rtnmi Fri, 14 Mar 2008 23:28:22 +0100 http://www.cncinformation.com/cnc-ecourse-videos-learn-cnc-cnc-basics-video/cnc-ecourse-day-1-introduction-to-cnc-video-2#pc_3 good job!............ - drgen Sat, 16 Feb 2008 09:26:10 +0100